|
-
-
-
-
-
- Local Authority Tower Blocks, London
- Water Tower Conversion, Hertfordshire
- Listed Blacksmith's Forge, Warwickshire
- Historic Manor House, East Yorks
- Barn Conversion, Tewkesbury
- Protected Properties, St Helier, Jersey
- Parade of Shops, Oxford
- St Sophia's Church, Scotland
- Private House, Hampshire
- Natural History Museum, London
- Private House, Glastonbury
- Stone Cottages, near Inverness
- Multi Storey Car Park, Newport, Gwent
- Woolwich Arsenal, London
- Private House, Norwich
- Bridgford Point, Nottingham
- Penygelli Primary School, Wrexham
|

- One-piece grade 304 or 316 stainless steel tie.
- Type 3 and Type 6 ties with self-tapping
helical design.
- Secure and lasting stress-free connection.
- Rapid, easy hammer-driven installation,
through insulation.
- Suitable for use with warm frame rigid
insulation.
- Great axial strength resists all wind loads.
- Multiple drip points prevent cross cavity
water transfer.
|
- Excellent holding power in timber, mortar,
masonry and resin.
- Installed through insulation without
affecting thermal properties.
- Hammered directly into timber stud, exactly
where required.
- Hammered directly into timber stud, exactly
where required.
- No disturbance to newly laid brickwork.
- No loosening of internal drywall fasteners.
- Suitable for cavities up to 125mm.
|
|
| Load tie into hand held support tool. Position as required as outer leaf masonry is constructed. Hammer into timber stud, through insulation when fitted, and fit retaining clip. |
Outer end of tie fully embedded in masonry
leaf mortar. |
|
50 |
195 |
220 |
|
75 |
220 |
245 |
|
100 |
245 |
270 |
|
125 |
270 |
295 |
125+ |
Consult Helifix Technical Sales
Team |
Type 2 |
Not applicable |
Type 3 |
With 75mm Timber Penetration |
Type 6 |
With 50mm Timber Penetration |
Minimum Tie Density
(To be used as a guide only) |
4.4 Ties per m2 |
Nominal Diameter |
4.5mm |
|
If your TimTie application involves a building of three
storeys or more, call Helifix Ltd for advice on 020 8735 5222. |
|